Description
- Brand: Foxboro
- Full Model Number: AD916CC
- System/Series Family: Foxboro I/A Series 200 I/O; associated with FBM237 analog output applications
- Core Function: Interconnection cable assembly linking the FBM237 I/O subsystem to its associated field termination arrangement
- Top 3 Technical Specifications:
- Application: FBM237 analog output termination interface
- Host Module Configuration: 8-channel analog output with 4–20 mA HART capability, subject to the installed FBM237 configuration
- Cable Length and Connector Configuration: Verify against the AD916CC nameplate, assembly drawing, and existing installation
- Stock Status: Subject to physical inventory verification
- Available Condition: New Original, New Surplus, or Tested Used, subject to actual stock
- Replacement Requirement: Confirm exact part number, revision, cable length, and termination assembly
- Warranty: Coverage and duration confirmed in the sales quotation
Technical Product Introduction
An analog output fault does not always originate in the Foxboro control module. Damaged conductors, loose connectors, or an incorrectly matched termination cable can interrupt the signal path between the I/O hardware and field wiring. The Foxboro AD916CC is identified in supplier listings as a termination cable assembly associated with the FBM237 application in the I/A Series 200 architecture. Its function is to support the required physical connection between the I/O subsystem and the associated termination hardware. For maintenance teams dealing with lost control-valve commands or unexplained output-channel faults, verifying the cable assembly before replacing the electronic module can prevent unnecessary hardware expenditure and extended troubleshooting.
The associated FBM237 provides eight analog output channels with 4–20 mA HART capability, according to published I/O integration documentation. Those specifications describe the host module, not the cable itself. The practical benefit of a correctly matched replacement is preservation of the existing field-wiring arrangement and signal-channel assignments. During procurement, check the complete part number and physical assembly rather than relying on a shortened model designation. Supplier references identify AD916CC with termination applications, while published integration documentation also references P0916CC for -related connections (the exact relationship between these part numbers should be verified before ordering). Correct identification reduces the risk of receiving a cable that fits mechanically but does not match the intended termination interface.
Application Scenarios & Field Realities
- Control-valve position and flow regulation: When a valve command disappears from one output channel, inspect the field termination cable alongside the diagnostics. Loose contacts or damaged conductors can interrupt the command path even when the control strategy and controller remain operational.
- Refinery and chemical process control: In systems regulating pump speed, valve position, or other continuously modulated process variables, a termination wiring fault can cause an output channel to behave unexpectedly. Before replacing the I/O hardware, compare the affected channel’s diagnostic information with the actual current measured at the field side.
- Power generation and utility systems: During scheduled cabinet maintenance, replacement of a worn cable assembly may be necessary to restore the original termination arrangement. Record the existing connector orientation, routing, and channel assignments before disconnecting any conductor.
- Legacy DCS maintenance and spare-parts recovery: When an older I/A Series cabinet must remain in service, matching the installed termination hardware is more important than selecting a cable based on appearance alone. Verify the suffix, revision, mating connector, and documented application before approving the replacement.

Foxboro AD916CC FBM237

Migration Compatibility & Installation Traps
Replacement Compatibility Matrix
| Replacement Category | AD916CC Engineering Assessment |
|---|---|
| Drop-in Replacement | Conditional. Accept only after confirming the complete part number, revision, physical connectors, cable length, pin assignment, and termination hardware. |
| Software Compatible | The passive cable assembly does not have an independent firmware version. The associated configuration should not require changes for a verified like-for-like cable replacement. |
| Hardware Modification Required | Potentially. A different connector arrangement, wiring map, cable length, or termination assembly may require an engineered change. Do not modify wiring without approved drawings. |
| Migration to Another I/O Platform | Requires engineering review of the output signal type, termination interface, wiring allocation, HART requirements, and target control-system design. Mechanical fit alone does not establish compatibility. |


